Congratulations on the purchase of your new Handheld Waterproof and Explosion Proof Flashlight. Please read these instructions carefully to familiarize yourself with the safe operation and maintenance of your new flashlight. Following these instructions will insure many years of safe and dependable service. Table of Contents I.
I. Assembly and Operation I. Assembly II. Operation Unscrew the bottom cap and install approved This flashlight features a simple slide switch batteries like shown below. Once batteries have for easy operation. Operators slide the switch been placed, screw the bottom cap back on. up to turn on, down to turn off or in the middle for momentary.
II. Bulb Replacement Replacement Begin by unscrewing the lens cap of the flashlight. The light housing is held together with the lens cap by clicking into place. To separate the the housing and the lens cap simply apply force and pull them apart. (Note: The bulb is held in place via a spring attached to the lens, upon separation of the housing and lens cap the bulb will be free, be careful not to drop, lose, or break the bulb.)
III. Safety Warnings and Ratings For personal safety, always follow the safety instructions in this manual to ensure safe and long- term use. Failing to do so can result in damage to the product or serious bodily injury. I. Safety Warnings II.
Upon examination by Larson Electronics’, if the unit is found to be defective it will be repaired or replaced at no charge. Larson Electronics’ WARRANTY does not apply to defects resulting from any action of the purchaser, including but not limited to mishandling, improper interfacing, operation outside of design limits, improper repair, or unauthorized modification.
Need help?
Do you have a question about the LE-2317C and is the answer not in the manual?
Questions and answers