Radio - Philips Htb3580/40 User Manual

3
Select a picture, and then press
start the slideshow.
4
Press to stop slideshow.
5
Press again to stop music.
Note
•
Make sure that the picture and audio formats are
supported by your home theater (see 'File formats' on
page 28).

Radio

Listen to FM radio on your home theater, and
store up to 40 radio stations.
Note
•
AM and digital radio are not supported.
•
If no stereo signal is detected, you are prompted to
install the radio stations again.
1
Connect the FM antenna to the FM
ANTENNA on your home theater.
• For the best reception, place the
antenna away from your TV or other
sources of radiation.
2
Press SOURCE repeatedly to switch to
radio source.
» If you have already installed the radio
stations, the last channel that you
listened to is played.
» If you have not installed any radio
stations, the message AUTO
INSTALL...PRESS PLAY appears on
the display panel. Press
install radio stations.
3
Use the remote control to listen or to
change radio stations.
(Play) to
(Play) to
Play buttons
Button Action
/ Select a preset radio station.
or
Alphanumeric
buttons
Navigation
Left/Right: Search for a radio
buttons
station.
Up/Down: Fine tune a radio
frequency.
Press to stop the installation
of radio stations.
Press and hold to erase the
preset radio station.
Manual:
1) Press
2) Press
3) Press
Automatic: Press and hold for
three seconds to reinstall the
radio stations.
SUBTITLE /
Toggle between the stereo
AUDIO
and mono sounds.
Tuning grid
In some countries, you can toggle the FM tuning
grid between 50 kHz and 100 kHz.
1
Press SOURCE repeatedly to switch to
radio source.
2
Press .
3
Press and hold
50 kHz or 100 kHz.
.
/ to select your
preset.
again to store the
radio station.
(Play) to toggle between
EN
19