Maintenance - Husqvarna 522HDR60S Operator's Manual

2. Pull the starter rope handle slowly with your right
hand until you feel some resistance, then pull the
starter rope handle quickly and with force. Continue
until the engine starts.
Note: For more information about how to start the
product, refer to To start the product with a cold engine
on page 9 .
To stop the product
• Move the stop switch to the stop position to stop the
engine.
CAUTION: The stop switch automatically
goes back to run position.
To operate the product
1. Start near the ground and move the product up
along the hedge when you cut the sides. Make sure
that the body of the product does not touch the
hedge.
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.
Maintenance schedule

Maintenance

Clean the external surface.
Clean the muffler, exhaust pipe and engine from leaves, dirt and unwanted lubri-
cant.
Make sure that the cutting attachment does not move at idle speed.
Do a check of the stop switch.
10
WARNING: Make sure that the front of
the cutting equipment does not touch the
ground.
2. Adjust the speed to align with the work load.
3. Hold the product near your body for a stable work
position.
4. Be careful and operate the product slowly.
Maintenance
Before After 40 After 100
operation h h
After each operation.
After each operation.
X
X
904 - 003 - 19.03.2019