Intended Use; Assembly And Adjustments; Operation - Craftsman CMCHTS860 Instruction Manual

6. Do not freeze or immerse the charger in water or any
other liquid.
Charger Cleaning Instructions

WARNING:
the charger from the AC outlet before cleaning. Dirt
and grease may be removed from the exterior of the
charger using a cloth or soft non-metallic brush. Do
not use water or any cleaning solutions.
SAVE THESE INSTRUCTIONS FOR
FUTURE USE
COMPONENTS (FIG. A)

Intended Use

This hedge trimmer is designed for residential use.
DO nOT use under wet conditions or in presence of
flammable liquids or gases.
DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.

ASSEMBLY AND ADJUSTMENTS


WARNING:
serious personal injury, turn unit off and remove
the battery pack before making any adjustments
or removing/installing attachments or
accessories. An accidental start-up can cause injury.
Switch (Fig. B)

WARNING:
switch in the ON position.

CAUTION:
than 3/4" (19 mm). Use the trimmer only for cutting
normal shrubbery around houses and buildings.
NOTE: Powersaw can cut stems and branches up to
1.5" (38.1 mm).
To turn the unit on, push the lock-off switch
shown in Figure B, and squeeze the trigger switch
the unit is running, you may release the lock off switch.
In order to keep the unit running you must continue to
squeeze the trigger. To turn the unit off, fully release the
trigger and allow the lock-off switch
Shock hazard. Disconnect
To reduce the risk of
Never attempt to lock a
Do not cut stems greater
forward as
2
1 . Once
2 to engage.
Fig. B
1

OPERATION


WARNING:
serious personal injury, turn unit off and remove
the battery pack before making any adjustments
or removing/installing attachments or
accessories. An accidental start-up can cause injury.
Installing and Removing the Battery Pack
(Fig. C)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack
8
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button 9 and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of this manual.
Fig. C
English
2
To reduce the risk of
into the tool handle, align the
9
8
7