Fujitsu FI-5220C Operator's Manual page 11

Safety Precautions(3)
fi-5120C / fi-5220C Image Scanner Operator Guide
Safety Precautions (3)
CAUTION
Do not install the scanner on unstable surfaces.
Make sure that the scanner is installed on a flat, level surface and that none of its parts extend
beyond the surface top, such as a desk or table. Do not install the scanner on unstable surfaces.
Install the scanner on a level surface that is free of vibration to prevent it from falling.
Install the scanner on a strong surface that will support the weight of the scanner and other devices.
Firmly insert the power plug.
Firmly insert the power plug as far it can go into the power outlet.
Do not block the ventilation ports.
Do not block the ventilation ports. Blocking the ventilation ports generates heat inside of scanner,
which may result in fire or scanner failure.
Do not place heavy objects or stand on top of the scanner.
Do not place heavy objects on the scanner or use the scanner's surface top to perform other work.
Improper installation might cause injuries and equipment failure.
Do not use the scanner immediately after moving it from a cold place
into a warm room.
Do not use the device immediately after moving it from a cold place into a warm room. Condensation
may occur, which might lead to scanning errors. Let the device dry about one or two hours before
you use it.
Before moving the scanner, disconnect the power plug from the power
outlet.
Do not move the scanner with the power and interface cables connected as this can damage the
cables, which can later cause fire, electric shock as well as injury.
Before moving the scanner, be sure to disconnect the power plug from the power outlet, and all other
data cables. Make sure that the floor is free of any obstructions.
file://///Hd-htgle21/Manual/fi-5120C_5220C-lynx2/OG/R03/contents/EN/cReg/cReg04_03.htm2006/08/29 15:59:33
1 2
1 2
All Rights Reserved Copyright 2006 © PFULIMITED
TROUBLE SHOOTING
CONTENTS MAP
TOP
4
3
4
3