Related Manuals for Texas Instruments LMX2582EVM
Summary of Contents for Texas Instruments LMX2582EVM
- Page 1 LMX2582EVM High Performance, Wideband PLLatinum™ RF Synthesizer Evaluation Board Operating Instructions User's Guide Literature Number: SNAU194 December 2015...
- Page 2 Contents ......................Evaluation Board Setup ..................EVM Software Startup Instructions ...................... EVM Software Navigation ........................... Schematic ....................................................Layout Contents SNAU194 – December 2015 Submit Documentation Feedback Copyright © 2015, Texas Instruments Incorporated...
- Page 3 NOTE: Phase noise of input signal should be below –150 dBc/Hz at 10-kHz offset for 100-MHz signal, otherwise the input reference noise will dominate the in-band phase noise at RF output. The On-board Oscillator is only at –134 dBc/Hz. SNAU194 – December 2015 Evaluation Board Setup Submit Documentation Feedback Copyright © 2015, Texas Instruments Incorporated...
- Page 4 Use a balan if you are using differential-ended. 4. Programming Interface (a) Connect your laptop to the EVM as shown with included USB2ANY module. Evaluation Board Setup SNAU194 – December 2015 Submit Documentation Feedback Copyright © 2015, Texas Instruments Incorporated...
- Page 5 SNAU194 – December 2015 EVM Software Startup Instructions 1. Download TICS software from TI.com: http://www.ti.com/tool/TICSPRO-SW 2. To start the EVM software, open TICS.exe from installed directory. SNAU194 – December 2015 EVM Software Startup Instructions Submit Documentation Feedback Copyright © 2015, Texas Instruments Incorporated...
- Page 6 MUXOUT_SEL=0 for readback. You can also read a register by the name of the register in Register/Field Name section. 4. PLL • Fosc: Enter the input signal frequency between 5 to 1400MHz EVM Software Navigation SNAU194 – December 2015 Submit Documentation Feedback Copyright © 2015, Texas Instruments Incorporated...
- Page 7 Enter a register in Load Register or delay in seconds. • You can run and stop the commands in a single burst or continuous loop. SNAU194 – December 2015 EVM Software Navigation Submit Documentation Feedback Copyright © 2015, Texas Instruments Incorporated...
- Page 8 VBIASVCO CWX813-100.0M µF 100MHz 142-0701-851 VBIASVCO2 µF R14p 10µF VBIASVARAC Vtune_TP OSCinP 0.1µF OSCINP 0.1µ OSCINM OSCinM External Input Frequency Option 142-0701-851 LMX2582RHAR Figure 4-1. Schematic Schematic SNAU194 – December 2015 Submit Documentation Feedback Copyright © 2015, Texas Instruments Incorporated...
- Page 9 RES, 49.9, 1%, 0.063 W, 0402 Vishay-Dale CRCW040249R9FKED RES, 680, 1%, 0.1 W, 0603 Yageo America RC0603FR-07680RL RES, 330 Ω, 5%, 0.1 W, 0603 Yageo America RC0603JR-07330RL SNAU194 – December 2015 Submit Documentation Feedback Copyright © 2015, Texas Instruments Incorporated...
- Page 10 High Performance, Wideband PLLatinum RF Synthesizer, Texas Instruments LMX2582RHAR RHA0040C Header (shrouded), 100mil, uWire 52601-S10-8LF 5x2, Gold plated, SMD OSC 100.0000 MHZ 3.3 V ±25 Connor-Winfield CWX813-100.0M PPM SMD SNAU194 – December 2015 Submit Documentation Feedback Copyright © 2015, Texas Instruments Incorporated...
- Page 11 Chapter 6 SNAU194 – December 2015 Layout Figure 6-1. Top Overlay Figure 6-2. Top Solder SNAU194 – December 2015 Layout Submit Documentation Feedback Copyright © 2015, Texas Instruments Incorporated...
- Page 12 Figure 6-3. Top Layer Figure 6-4. Ground Layer Figure 6-5. Power Layer Layout SNAU194 – December 2015 Submit Documentation Feedback Copyright © 2015, Texas Instruments Incorporated...
- Page 13 Figure 6-6. Bottom Layer Figure 6-7. Bottom Solder Figure 6-8. Bottom Overlay SNAU194 – December 2015 Layout Submit Documentation Feedback Copyright © 2015, Texas Instruments Incorporated...
- Page 14 Figure 6-9. Drill Drawing Figure 6-10. Board Dimensions Layout SNAU194 – December 2015 Submit Documentation Feedback Copyright © 2015, Texas Instruments Incorporated...
- Page 15 STANDARD TERMS AND CONDITIONS FOR EVALUATION MODULES Delivery: TI delivers TI evaluation boards, kits, or modules, including any accompanying demonstration software, components, or documentation (collectively, an “EVM” or “EVMs”) to the User (“User”) in accordance with the terms and conditions set forth herein. Acceptance of the EVM is expressly subject to the following terms and conditions.
- Page 16 FCC Interference Statement for Class B EVM devices NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
- Page 17 【無線電波を送信する製品の開発キットをお使いになる際の注意事項】 開発キットの中には技術基準適合証明を受けて いないものがあります。 技術適合証明を受けていないもののご使用に際しては、電波法遵守のため、以下のいずれかの 措置を取っていただく必要がありますのでご注意ください。 1. 電波法施行規則第6条第1項第1号に基づく平成18年3月28日総務省告示第173号で定められた電波暗室等の試験設備でご使用 いただく。 2. 実験局の免許を取得後ご使用いただく。 3. 技術基準適合証明を取得後ご使用いただく。 なお、本製品は、上記の「ご使用にあたっての注意」を譲渡先、移転先に通知しない限り、譲渡、移転できないものとします。 上記を遵守頂けない場合は、電波法の罰則が適用される可能性があることをご留意ください。 日本テキサス・イ ンスツルメンツ株式会社 東京都新宿区西新宿６丁目２４番１号 西新宿三井ビル 3.3.3 Notice for EVMs for Power Line Communication: Please see http://www.tij.co.jp/lsds/ti_ja/general/eStore/notice_02.page 電力線搬送波通信についての開発キットをお使いになる際の注意事項については、次のところをご覧くださ い。http://www.tij.co.jp/lsds/ti_ja/general/eStore/notice_02.page SPACER EVM Use Restrictions and Warnings: 4.1 EVMS ARE NOT FOR USE IN FUNCTIONAL SAFETY AND/OR SAFETY CRITICAL EVALUATIONS, INCLUDING BUT NOT LIMITED TO EVALUATIONS OF LIFE SUPPORT APPLICATIONS.
- Page 18 Notwithstanding the foregoing, any judgment may be enforced in any United States or foreign court, and TI may seek injunctive relief in any United States or foreign court. Mailing Address: Texas Instruments, Post Office Box 655303, Dallas, Texas 75265 Copyright © 2015, Texas Instruments Incorporated...
- Page 19 IMPORTANT NOTICE Texas Instruments Incorporated and its subsidiaries (TI) reserve the right to make corrections, enhancements, improvements and other changes to its semiconductor products and services per JESD46, latest issue, and to discontinue any product or service per JESD48, latest issue.
Need help?
Do you have a question about the LMX2582EVM and is the answer not in the manual?
Questions and answers