Electrolux EKC96150A User Manual page 27

Table of Contents

Advertisement

Minimum distances
Dimen-
sion
A
B
12.2 Levelling
Use small feet on the bottom of appliance
to set the appliance top surface level with
other surfaces.
12.3 Anti-tilt protection
CAUTION!
You must install the anti-tilt pro-
tection. If you do not install it, the
appliance can tilt.
Your appliance has the symbol
shown on the picture (if applica-
ble) to remind you about the in-
stallation of the anti-tilt protection.
mm
2
685
Make sure you install the anti-tilt
protection at the correct height.
1.
Set the correct height and area for
the appliance before you attach the
anti-tilt protection.
2.
Install the anti-tilt protection 77 mm
down from the top surface of the ap-
pliance and 49 mm from the left side
of the appliance into the circular hole
on the bracket (see fig.). Screw it into
the solid material or use applicable re-
inforcement (wall).
3.
You can find the hole on the left side
at the back of the appliance (see fig.).
Lift the front of the appliance (1) and
put it in the middle of the space be-
tween the cupboards (2). If the space
between the bench cupboards is
larger than the width of the appliance,
you must adjust the side measure-
ment to centre the appliance.
Make sure that the surface behind the
appliance is smooth.
12.4 Electrical installation
The manufacturer is not responsi-
ble if you do not follow the safety
precautions from the chapter
"Safety information".
This appliance is supplied without a main
plug or a main cable.
Applicable cable types: H07 RN-F, H05
RN-F, H05 RRF, H05 VV-F, H05 V2V2-F
(T90), H05 BB-F.
ENGLISH
27
49 mm
77 mm
2
1

Advertisement

Table of Contents
loading

Table of Contents