Table of Contents
Advertisement
3 Get started
Caution
•
Use of controls or adjustments or performance of
procedures other than herein may result in hazardous
radiation exposure or other unsafe operation.
Always follow the instructions in this chapter in
sequence.
Charge the WeCall speaker
•
Connect the WeCall speaker to a PC/Mac
through the supplied USB cable.
» The charge indicator turns red.
» When the WeCall speaker is fully
charged, the charge indicator turns off.
•
You can also charge the WeCall speaker
through a USB power adapter (not
supplied).
Tip
•
When the battery is low, the charge indicator flashes
red.
•
It takes approximately 2 hours to fully charge the
WeCall speaker.
•
The fully charged WeCall speaker supports
approximately 8 hours of operation.
6
EN
Turn on the WeCall speaker
Slide the power switch to the ON position.
•
» In Bluetooth mode, the status indicator
turns blue.
» In USB mode, the source indicator
turns green.
•
To turn off the WeCall speaker, slide the
power switch to the OFF position.
Connect the WeCall speaker
Option 1: Connect to a Bluetooth-
enabled device
You can pair the WeCall speaker with a
Bluetooth-enabled mobile device (such as
your mobile phone or tablet) or PC/Mac. Then
you can enjoy music from the WeCall speaker,
or use it as a speaker phone when you make
mobile or VoIP calls.
Note
•
The effective operation range between the WeCall
speaker and your Bluetooth-enabled device is
approximately 10 meters (30 feet).
1
Slide the source switch at the bottom of
the WeCall speaker to the
position.
Advertisement
Table of Contents
