Operating Instructions
(continued)
TIMER: DELAY STOP / START FEATURE
FIRST
DO THIS:
PRESS
TIMER BUTTON
Note: For Delay Stop, the unit must be in the On position.
Note: For Delay Start, the unit must be in the Off position.
First, Press TIMER button, then adjust timer setting, tap or hold the UP arrow (
timer at 0.5 hour increments, up to 10 hours, then at 1 hour increments up to 24 hours. The control will count down the time
remaining until start (8, 7.5, 7, etc.). The Delay Start Operation automatically selects cooling with maximum Fan speed (if Cool,
Energy Saver, or Fan Only was the last mode selected) . The temperature maintained will be the same as previously set. To change
the set temperature, press "COOL" then Up or Down arrows until the desired temperature is indicated on the display. After 5
seconds, the control will automatically change the display back to the hours remaining until the unit will start/stop. Pressing the
unit On/Off button at any time will cancel the Delay Start/Stop function. The Delay Start/Stop Feature will work until the unit either
starts or stops. Once that happens the above steps have to be repeated again.
CHECK FILTER FEATURE, YOU WILL SEE:
Note: This feature is a reminder to clean the Air Filter (See
Care and Cleaning) for more efficient operation. The LED
(light) will illuminate after 250 hours of operation. To reset
after cleaning the filter, press the "Filter Reset" button and
the light will go off.
CLEAN AIR FEATURE(on some models):
DO THIS:
PRESS
CLEAN AIR
BUTTON
2009 Electrolux Home Products, Inc.
THEN
DO THIS:
PRESS
UP/DOWN BUTTONS
Operating Instructions
YOU WILL SEE HOW MUCH TIME IS CHOSEN:
) or the DOWN arrow (
PRESS FILTER
RESET BUTTON
Note: When this feature is "ON", the electronic air purifier is
energized to remove pollen and impurities from the air. To
cancel this feature, press the Clean Air button (the LIGHT
will turn off).
Note: This feature can be activated on the unit touch pad
ONLY.
) to change delay
DO THIS:
All rights reserved.
7