Changing The Water And Air Filters - Electrolux EI28BS56I Use And Care Manual

28

Changing The Water and Air Filters

Your refrigerator is equipped with separate water and
air filtering systems. The water filter system filters all
dispensed drinking water, as well as the water used to
produce ice. The air filter removes odors and impurities
from the refrigerator compartment.
NOTE
The control panel includes controls to monitor the
status of your water and air filters. See the Controls
section for more information.
About your advanced water filter
The PureAdvantage
filter system is tested and certified
by NSF International, the nationally
respected, not-for-profit certification
organization for public health safety. The
PureAdvantage
and certified to ANSI/NSF Standards 42 and 53 for
the reduction of claims specified on the performance
data sheet.
Do not use with water that is microbiologically unsafe
or of unknown quality without adequate disinfection
before or after the system. Systems certified for cyst
reduction may be used on disinfected waters that may
contain filterable cysts.
• Rated Capacity - 400 gallons for
PureAdvantage
• Rated service flow - .5 gallons per minute
• Maximum Rated Pressure - 100 pounds per
square inch
• Recommended Minimum Operating Pressure:
30 pounds per square inch
• Operating Temp.: Min. 33°F, Max. 100°F
Water filter
The water filter is located at the lower left side of the
fresh food compartment.
Replacing your PureAdvantage
filter
In general, you should change the water filter every
six (6) months to ensure the highest possible water
quality. The Water Filter Status light on the Touch
Panel prompts you to replace the filter after a standard
amount of water (400 gallons) has flowed through the
system.
If your refrigerator has not been used for a period of
time (during moving for example), change the filter
before reinstalling the refrigerator.
ice and water
TM
ice and water filter system is tested
TM
ice and water filter
TM
water
TM
It is not necessary to turn the water supply off to
change the filter. Be ready to wipe up any small
amounts of water released during the filter replacement.
1 Turn Off the ice maker on the control panel.
2 Push the filter release button above the cartridge
to disconnect it.
Push Water Filter Button
3 Slide the old water filter cartridge straight out of
the housing and discard it.
4 Unpack the new filter cartridge and remove the
two (2) protective caps covering the inlet and exit
of the filter. Slide the filter gently into the housing
until it stops against the snap-in connector at the
back of the housing.