Table of Contents
Advertisement
Components to clean
No.
Name
1
Filter cover
2
Metal grease filter
3
Container
4
Hob
5
Control panel
6
Overflow container
7
Housing cover
8
Activated charcoal filter (only in air recirculation mode)
Hob surround (only on appliances with hob
surrounds)
To prevent damage to the hob surround, observe the
following instructions:
Only use warm soapy water
■
Wash new dish cloths thoroughly before use.
■
Do not use harsh or abrasive cleaning agents.
■
Do not use a glass scraper or sharp objects.
■
Hob
Clean the hob each time you use it. This will prevent
food remnants from becoming burned on. Do not clean
the hob until the residual heat indicator has gone out.
Remove boiled-over liquids immediately and do not
allow any food remains to dry on.
Clean the hob with a damp dish cloth and dry it with a
cloth or towel to prevent limescale build-up.
Stubborn dirt is best removed with a glass scraper or
glass ceramic cleaner (available from retailers). Follow
the manufacturer's instructions.
You can obtain a suitable glass scraper (article no.
00087670) from our after-sales service or through our
online shop.
Using a special sponge for cleaning glass-ceramic
hobs achieves great cleaning results.
Ventilation system
The filter must be regularly cleaned or replaced in order
to guarantee efficient filtration of odours and grease.
Metal grease filter
The metal grease filters should be cleaned every
30 operating hours or at least once a month.
:
Warning – Risk of fire!
Grease deposits in the grease filter may catch fire.
Clean the grease filter at least once a month.
Never operate the appliance without the grease filter.
Activated charcoal filters
The activated charcoal filter should be replaced
regularly. The saturation indicator on your appliance will
tell you how frequently this needs to be done.
Saturation display
If the metal grease filter or activated charcoal filter
becomes saturated, a signal will sound once the
appliance has been switched off.
The following symbols will light up in the display panel:
Metal grease filter:
■
Activated charcoal filter:
■
Metal grease filter and activated charcoal filter:
■
" ‚‹
and
"‚‚
light up alternately
Do not wait any longer to clean the metal grease filter or
replace the activated charcoal filter.
Once you have cleaned or replaced the relevant filters,
reset the saturation indicator so that the
indicators go out.
"‚‚
After the appliance has been switched off,
lights up.
Touch the
symbol.
a
1.
A signal tone will sound. The metal grease filter
saturation indicator has now been reset.
If
lights up, touch the
"‚‚
2.
A signal tone will sound. The activated charcoal filter
saturation indicator has now been reset.
Cleaning
lights up
"‚ ‹
" ‚‚
lights up
"‚ ‹
"‚‹
symbol again.
a
en
and
or
"‚‚
41
Advertisement
Table of Contents
