Maintaining The Appliance; Troubleshooting - Dirt Devil CAVALIER Instruction Manual

Maintaining the appliance

Removing the rechargeable battery
Press and hold the locking mechanism for the
rechargeable battery to release it.
rechargeable battery from the appliance (Fig. 12 ).
Emptying the dust bin
Open the release catch on the connection port
to disconnect the base appliance from the suction
tube or the attached nozzles (Fig. 3 ).
appliance with the dust bin over a waste bin.
the locking mechanism on the dust bin cover
(Fig. 13 ). The dust bin cover opens downwards
and the dust falls out.
Cleaning the filter
NOTE:
The appliance and the filter should be cleaned
regularly in order to maintain the suction power.
Press the filter release button at the rear of the
appliance. Pull the filter holder out of the appli-
ance (Fig. 14 ). Remove the filter from the mount
(Fig. 15 ). Tap out the filter and the mount over a
waste bin. Rinse out the filter under running water
(max. 40 °C). Leave the filter to dry for at least 24
hours before you insert the filter and mount into the
appliance again.
Cleaning the cyclone unit
Empty the dust bin, > „Emptying the dust bin" on
page 18. Press and hold the dust bin release catch
on the underside of the appliance
(Fig. 16 /1). Tip the dust bin towards the connec-
tion port for the suction tube and pull it downwards
(Fig. 16 ). Turn the filter fleece anti-clockwise and
pull it downwards from the cyclone unit (Fig. 17 ).
Turn the cyclone unit anti-clockwise and pull it
downwards from the appliance (Fig. 18 ).
the filter fleece and the cyclone unit over a waste
bin. Use a dry cloth to remove any remaining dust
and dirt.
EN
Inserting the cyclone unit
Connect the cyclone unit to the appliance so that
the two arrows on both components line up.
the cyclone unit clockwise so that it clicks into place.
Remove the
Attach the filter fleece to the cyclone unit with the
seal facing away from the appliance.
fleece clockwise to lock it in place.
bin on the appliance in a slightly inclined position.
Push the dust bin towards the handle to lock it in
place.
Removing and cleaning the brush roller
Hold the
Press
Release floor nozzle as necessary and remove it
from the suction tube (Fig. 4 ).
locking mechanism on the underside of the floor
nozzle to the side (Fig. 20 ).
from the floor nozzle (Fig. 21 ).
and hairs from the floor nozzle and from the brush
roller. If necessary, you can carefully use a pair of
scissors as an aid.
Accessories
• Hygienic exhaust filter - 0698002 (Fig. 22 /A )
• Brush roller- 0698413 (Fig. 22 /B )
• Separator with filter - 0698401 (Fig. 22 /C )
• Dust bin assembly - 0698405 (Fig. 22 /D )
• Wall mount - 0698011 (Fig. 22 /E )
• Mains adapter - 0698003 (Fig. 22 /F )
• Rechargeable battery - 0698004 (Fig. 22 /G )

Troubleshooting

Before you contact our customer service department
or send the appliance to the Dirt Devil customer
service department, you will find a lot of additional
information in the service area of our website which
will help you solve problems:
www.dirtdevil.de/service
Switch off the appliance before you start trou-
Tap out
bleshooting. Never use a faulty appliance, mains
adapter or rechargeable battery.
!
WARNING!
18
Turn
Turn the filter
Place the dust
Push the brush
Lift the brush roller
Remove any dirt