Timer Operation (On/Off Timer); When The Air Conditioner Is Not Going To Be Used For Along Time - Mitsubishi Electric MS-18RV Operating Instructions Manual

TIMER OPERATION (ON/OFF TIMER)

TIMER
It is convenient to set the timer when you go to
bed, when you get home, when you get up, etc.
˚C
CLOCK
AMPM
AMPM
TOO TOO
ON/OFF
WARM COOL
FAN STOP
I FEEL COOL
VANE START
FAN DRY
MODE HR.
ECONO COOL MIN.
RESET CLOCK
12
How to set the ON timer
START
1
Press the button during operation.
Each time the button is pressed, the ON timer mode
alternates between ON and OFF.
2
Set the time of the timer using the
MIN.
buttons.
HR.
Each time the button is pressed, the set time in-
MIN.
creases by 1 hour; each time the button is pressed,
the set time increases by 10 minutes.
To release the ON timer:
I
START
Press the button.
How to set the OFF timer
STOP
1
Press the button during operation.
Each time the button is pressed, the OFF timer mode
alternates between ON and OFF.
2
Set the time of the timer using the
MIN.
buttons.
HR.
Each time the button is pressed, the set time in-
MIN.
creases by 1 hour; each time the button is pressed,
the set time increases by 10 minutes.
To release the OFF timer:
I
STOP
Press the button.
Programming timer operation
The ON timer and the OFF timer can be used in combination.
The timer of the set time that is reached first will operate first.
(" " mark indicates the order of timer operations.)
I If the current time has not been set, the timer operation can-
not be used.
WHEN THE AIR CONDITIONER IS NOT GOING
TO BE USED FOR A LONG TIME
When it is not going to be used for a
long time:
1
Perform the FAN operation for 3 or 4 hours
to dry the inside of the air conditioner.
HR.
and
2
Turn off the breaker and/or disconnect the
power supply plug.
HR.
and
CAUTION
Turn off the breaker or disconnect the power sup-
ply plug when the air conditioner is not going to be
used for a long time.
Dirt may collect and this may cause a fire.
3
Remove the batteries from the remote con-
troller.
CAUTION
To prevent liquid leakage, take out all batteries when
the remote controller is not going to be used for a
long time.
When the air conditioner is to be
used again:
1
Clean the air filter and install it in the in-
door unit.
(Refer to page 13 for cleaning instructions.)
Clean the
filter before
installing.
2
Check that the air inlet and outlet of the
indoor/outdoor units are not blocked.
3
Check that the earth is connected correctly.
CAUTION
Earth the unit.
Do not connect the earth to a gas pipe, water pipe, light-
ning rod or the earth of a telephone. If the earthing is
incorrect, it may cause an electric shock.