Mainboard Removal
Prerequisite:
HDD (Hard Disk Drive) Module Removal
WLAN (Wireless Local Area Network) Module Removal
Speaker Module Removal
1. Locate mainboard (E) on lower cover. Refer to
2. Remove two (2) screws (A) from lower cover (Figure 3-35).
Figure 3-35. Mainboard Screws & WLAN Antennas
3. Remove adhesive tape (B) securing WLAN antennas to mainboard.
4. Remove WLAN antennas from mainboard.
5. Lift right side (B) of mainboard until edge is a few cm above lower cover as shown in
Figure
3-36.
3-36
A
B
Figure
3-29.
B
Machine Maintenance Procedures
0
A