Download Print this page

Dell 4310WX User Manual: Changing The Lamp

Dell 4310wx: user guide.
Hide thumbs

Advertisement

Changing the Lamp

CAUTION:
Safety Instructions as described on page 7.
Replace the lamp when the message "Lamp is approaching the end of its useful
life in the operation. Replacement suggested! www.dell.com/lamps" appears
on the screen. If this problem persists after replacing the lamp, contact Dell™. For
more information, see Contacting Dell™on page 76.
CAUTION:
of your projector.
CAUTION:
the lamp until the projector has been allowed to cool down for at least 30
minutes.
CAUTION:
lamps are very fragile and may shatter if touched. The shattered glass pieces
are sharp and can cause injury.
CAUTION:
and dispose or recycle according to state, local, or federal law. For more
information see www.dell.com/hg.
Turn off the projector and disconnect the power cord.
1
Let the projector cool for at least 30 minutes.
2
Loosen the two screws that secure the
3
lamp cover, and remove the cover.
Loosen the two screws that secure the
4
lamp.
Pull the lamp up by its metal handle.
5
NOTE:
Dell™ may require lamps
replaced under warranty to be returned
to Dell™. Otherwise, contact your local
waste disposal agency for the address
of the nearest deposit site.
Replace with the new lamp.
6
Tighten the two screws that secure the
7
lamp.
Replace the lamp cover and tighten the
8
two screws.
Before you begin any of the procedures in this section, follow the
Use an original lamp to ensure safe and optimal working condition
The lamp becomes very hot when in use. Do not attempt to replace
Do not touch the bulb or the lamp glass at any time. Projector
If the lamp shatters, remove all broken pieces from the projector
Troubleshooting Your Projector
69

Advertisement

   Related Manuals for Dell 4310WX

Comments to this Manuals

Symbols: 0
Latest comments: