Beater To Bowl Clearance - KitchenAid 5KSM150PSSWH4 Instructions Manual

Your Stand Mixer is adjusted at the factory so the flat beater just clears the
bottom of the bowl. If, for any reason, the flat beater hits the bottom of the
bowl or is too far away from the bowl, you can correct clearance easily.
1. Turn speed control to "O".
2. Unplug stand mixer or disconnect
power.
3. Lift motor head.
4. Turn screw (A) SLIGHTLY counter
clockwise (left) to raise flat beater
or clockwise (right) to lower flat
beater.
5. Make adjustment with flat beater,
so it just clears surface of bowl.
If you over adjust the screw, the
bowl lock lever may not lock into
place.
NOTE: When properly adjusted, the
flat beater will not strike on the
bottom or side of the bowl. If the flat
beater or the wire whip is so close
that it strikes the bottom of the bowl,
coating may wear off the beater or
wires on whip may wear.

Beater to Bowl Clearance

7
A