Optional Accessories; Maintenance - Makita RP2301FC Instruction Manual

Hide thumbs Also See for RP2301FC:
Table of Contents

Advertisement

009933
2. Adjusting the depth of cut
A small amount of depth of cut can be obtained by
turning this screw with a screwdriver from above
the table. (1.0 mm per a full turn)
Turning it clockwise makes the depth of cut greater
and turning it counterclockwise smaller.
1
009931

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or
the like. Discoloration, deformation or cracks may
result.
Replacing carbon brushes
001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps.
1. Threaded part in
the motor
bracket
1
1. Screwdriver
1. Limit mark
1
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
1
2
009869
After replacing brushes, plug in the tool and break in
brushes by running tool with no load for about 10
minutes. Then check the tool while running and electric
brake operation when releasing the switch trigger. If
electric brake is not working well, ask your local Makita
service center for repair.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers,
always using Makita replacement parts.

OPTIONAL ACCESSORIES

CAUTION:
These
accessories
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to
persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Straight & groove forming bits
Edge forming bits
Laminate trimming bits
Straight guide
Trimmer guide
Guide holder
Templet guides
Templet guide adapter
Lock nut
Collet cone 12 mm, 1/2"
Collet sleeve 6 mm, 8 mm, 10 mm
Collet sleeve 3/8", 1/4"
Wrench 24
Vacuum head set
12
1. Brush holder
cap
2. Screwdriver
or
attachments
Only use
accessory or
are

Advertisement

Table of Contents
loading

Table of Contents