Table of Contents
Advertisement
Product Dimensions
B
C
D
A. 27³⁄₄" (70.5 cm) max. depth with handle
¹⁄₈
B. 47
" (119.7 cm) overall height (max.) with leveling legs
screwed in all the way*
C. 36" (91.4 cm) cooktop height (max.) with leveling legs screwed
in all the way*
D. 29⁷⁄₈" (75.9 cm) width
⁵⁄₁₆
E. 25
" (64.3 cm) depth - back of range to front of cooktop**
F. Model/serial/rating plate (located on the frame behind a top
corner of the door or on either side of the drawer)
IMPORTANT: Range must be level after installation. Follow the
instructions in the "Level Range" section. Using the cooktop as a
reference for leveling the range is not recommended.
*Range can be raised approximately 1" (2.5 cm) by adjusting
the leveling legs.
**Front of door and drawer may extend further forward
depending on styling.
4
F
A
F
E
Cabinet Dimensions
Cabinet opening dimensions shown are for 25" (64.0 cm)
countertop depth, 24" (61.0 cm) base cabinet depth and
36" (91.4 cm) countertop height.
IMPORTANT: If installing a range hood or microwave hood
combination above the range, follow the range hood or
microwave hood combination installation instructions for
dimensional clearances above the cooktop surface.
A freestanding range may be installed next to combustible walls
with zero clearance.
E
A. 13" (33.0 cm) max. upper cabinet depth
¹⁄₈
B. 30
" (76.5 cm) min. opening width
C. For minimum clearance to top of cooktop, see NOTE*.
D. 30" (76.2 cm) min. opening width
E. Outlet - 8" to 22" (20.3 cm to 55.9 cm) from either cabinet,
7" (17.8 cm) max. from floor
F. Cabinet door or hinges should not extend into the cutout.
*NOTE: 24" (61.0 cm) minimum when bottom of wood or metal
cabinet is covered by not less than ¹⁄₄" (0.64 cm) flame retardant
millboard covered with not less than No. 28 MSG sheet steel,
0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or
0.020" (0.5 mm) copper.
30" (76.2 cm) minimum clearance between the top of the
cooking platform and the bottom of an uncovered wood or metal
cabinet.
A
C
B
D
F
Advertisement
Table of Contents
