Screen Position Adjustment; Connecting The Power Cord; Power Saving - Acer H233H User Manual

Screen position adjustment

To optimize the viewing position, you can adjust
the monitor tilt, using both of your hands to hold
the edges of the monitor. The monitor can be
adjusted to 15 degrees up or 5 degrees down.

Connecting the power cord

•
Check first to make sure that the power cord
you use is the correct type required for your
area.
•
The monitor has a universal power supply
that allows operation in either 100/120 V AC
or 220/240 V AC voltage area. No user-
adjustment is required.
•
Plug one end of the power cord to the AC
inlet, and plug the other end into an AC outlet.
•
For units using 120 V AC:
Use a UL-listed cord set, type SVT wire and plug rated 10 A/125 V.
•
For units using 220/240 V AC:
Use a cord set consisting of H05VV-F cord and plug rated 10 A/250 V. The
cord set should have the appropriate safety approvals for the country in
which the equipment will be installed.

Power saving

The monitor will be switched to "power saving" mode by the control signal
from the display controller, as indicated by the amber-colored power LED.
Power saving
The power saving mode will be kept until a control signal has been detected or
the keyboard or mouse is activated. The recovery time from "power saving"
mode back to "on" is around 3 seconds.
Mode
On
3
LED light
White
Amber