Programming Channels Automatically - Toshiba 19SL410U Owner's Manual

Programming channels automatically

Your TV can automatically detect all active channels
in your area and store them in its memory. After the
channels are programmed automatically, you can
manually add or erase individual channels in the
channel memory.
Note:
• You must configure the ANT/CABLE input
source before programming channels (
24).
• The automatic channel programming process
will erase channels that were previously
programmed into the TV's memory.
• To tune the TV to a channel not programmed in
the channel memory, you must use the
Channel Number buttons on the remote
control.
• Programming channels when the ANT/CABLE
input is configured for Cable will take
substantially longer than when the antenna
input is configured for Antenna. This is normal;
however, once channel programming is
finished, you should not have to repeat the
programming process again unless your Cable
TV service lineup changes significantly.
To program channels automatically:
1
Configure the antenna input source, if you have
not already done so (
2
Press and open the Setup menu.
3
Highlight Installation and press
Setup
Installation
REGZA-LINK Setup
Sleep Timer
PC Settings
Media Player
4
(A new set of Installation menu icons will appear,
as shown below.) Open the Terrestrial menu,
highlight Channel Program and press
Chapter 5: Setting up your TV
page
page 24).
.
to bring
up the Start Scan, and press
channel programming.
Installation
Terrestrial
Input Configuration
Channel Program
Channel Options
Channel Tuning Mode
Time Zone
Signal Meter
ANT/CABLE Antenna
Scanning channels, please wait...
Number of Channels Found - 73
Scanning Digital Channels
Found Channels - 118
The TV will automatically cycle through all the
antenna channels, and store all active channels in
the channel memory. While the TV is cycling
through the channels, the message "Scanning
channels, please wait..." appears (as shown
above).
5
To cancel channel programming, press
remote control (or highlight Cancel in the
onscreen display and press
When channel programming is finished, press
or to view the programmed channels.
again to begin
Auto
52%
Cancel
on the
).
25