Chapter 5: Setting Up Your Tv; Initial Setup; Selecting The Menu Language; Toshiba Logo Led - Toshiba 40G300U1 Owner's Manual

Initial Setup

When you first turn on or reset the TV, the Initial
Setup window will appear.
1無
In the Menu Language field, press t or u to
select your preferred language.
2無
Press t or u to select Time Zone and set your
desired time zone with t or u and press
3無
Next, the Location setting window will appear.For
normal home use, press t or u to select Home
and press .
4無
Next, ANT/CABLE In setup window will appear.
Press t or u to select the input source (Cable or
Antenna) for the ANT/CABLE input on the TV.
5無
If you select Antenna, the Channel Tuning Mode
setup window will appear. To tune only digital
channels, select Digital. To tune digital channels
preferentially over analog when entering channel
number directly, select Auto. For normal tuning,
select Standard. Press
Tuning.
6無
to select Start Scan and continue with
Press
the Auto Tuning.
You can stop the Initial Setup with
you do not finish the entire Initial Setup process, the
Initial Setup window will appear every time you turn
on the TV.

Selecting the menu language

You can choose from three different languages
(English, French and Spanish) for the on-screen
display of menus and messages.
To select the menu language:
1無
Press and open the Preferences menu,
highlight Menu Language.
2無
Press t or u to select your preferred menu
language.
3無
Press to close the Preferences menu.
30
40_46G300U1_EN-A5.indb 30

Chapter 5: Setting up your TV

.
to continue to Auto
. However if

TOSHIBA Logo LED

You can select TOSHIBA Logo LED either On or Off.
1無
Press and open the Setup menu, highlight
Logo LED.
2無
Press t or u to select either On or Off and press
Configuring the antenna input
source for the ANT/CABLE terminal
To configure the ANT/CABLE input source:
1無
Press and open the Setup menu.
2無
Highlight Installation and press
3無
(A new set of Installation menu icons will appear,
as shown below.) Open the Terrestrial menu,
highlight Input Configuration, and press
4無
Highlight ANT/CABLE In and press t or u to
select the input source (Cable or Antenna) for the
ANT/CABLE input on the TV.
5無
To save your new settings, highlight Done and press
. To revert to your original settings, highlight
Cancel and press
.
.
.
.
(continued)
2010/3/2 上午 11:32:58