Using The Remote Control To Control Your Other Devices - Toshiba 40G300U1 Owner's Manual

Using the remote control to
control your other devices
If you have a non-Toshiba device or a Toshiba device that
the remote control is not preprogrammed to operate, you
must first program the remote control to recognize the
device (if you have not already done so) ( pages 25–27).
To use your TV remote control to operate a:
Cable converter box or satellite receiver, set the
•
MODE SELECT switch to CABLE/SAT.
VCR, set the MODE SELECT switch to AUX 1.
•
DVD player or HTIB, set the MODE SELECT
•
switch to AUX 2.
Note: Even after the TV remote control is
programmed, it may not operate certain
features on any other devices. If this happens
and you wish to use those features, you will
need to use the device's original remote control.
Point the remote control
directly at the device.
16
17
18
19
40_46G300U1_EN-A5.indb 23
Chapter 3: Using the remote control
1無 POWER Turns the selected device on and off.
2無 Channel Numbers (0-9) Press to directly access
3無 +10 Press to directly access DVD chapters higher than
4無 TOP MENU Accesses a DVD's top menu.
5無 CH pq For channels programmed into the channel
6無 GUIDE Displays the channel guide in the CABLE/SAT
7無 INFO Displays TV status information on-screen.
8無 pqtu Press to navigate DVD menus (may not work
9無 ENTER Required by some satellite receivers and DVD
10無 DVD CLEAR Press to reset the title and chapter number.
11無 PLAY Begins playback of a tape or DVD.
12無 PAUSE Press during play or record mode to pause the
13無 STOP Stops the tape or DVD.
14無 SKIP
15無 FF Fast-forwards the tape or DVD. (Press during play
16無 SKIP
17無 REW Rewinds/reverses the tape or DVD. (Press
18無 TV/VCR To view one program while recording another,
19無 REC Starts tape recording.
20無 MODE SELECT switch Set to "TV" to control the TV;
channels (as opposed to
10.
memory (  page 31):
p selects the next higher channel.
q selects the next lower channel.
mode.
SET UP Accesses a DVD's setup menu in the AUX
mode.
on some DVD players).
players to activate certain functions.
picture; press again to restart.
Skips forward to locate later DVD chapters.
mode to view the picture moving rapidly forward.)
Skips back to beginning of current DVD
chapter, or locates previous chapters.
during play mode to view the picture moving rapidly
backward.)
press to select TV mode.
SEARCH selects a specific DVD chapter, title or time.
"CABLE/SAT" to control a cable converter box or
satellite receiver; "AUX 1" to control a VCR; "AUX 2"
to control a DVD player or HTIB.
).
23
2010/3/2 上午 11:32:47