Table of Contents
Advertisement
The TV's Controller, a small joy stick like button on the rear right side of the TV, lets you control the TV
without the remote control.
The product colour and shape may vary depending on the model.
✎
Function menu
Remote control sensor
Left
Follow these instructions facing the front of your TV.
✎
When selecting the function by moving the controller to the up/down/left/right directions, be sure
✎
not to press the controller. If you press it first, you cannot operate it to move the up/down/left/right
directions.
Before you use the TV camera for the first time you should check whether tape is attached at the rear
✎
of the TV camera. TV camera can be then used after adjusting the camera angle. If you do not intend
to use the TV camera, move the camera lens upwards so that the lens is not revealed. In this case,
Face recognition and Motion control are not available.
Power on
Adjusting the volume
Selecting a channel
Using the Function menu
Selecting the MENU (m)
Selecting the SMART HUB
(™)
Selecting a Source (s)
Power off (P)
To close the Menu, Smart Hub, or Source, press the Controller for more than 1 second.
✎
[PE8000-XU]BN68-04062J.indb 7
Using the TV's Controller (Panel Key)
m
R
P
Up(Rear)
Right
TV Controller
Down(Front)
Turn the TV on by pressing the Controller when the TV is in standby
mode.
Adjust the volume by moving the Controller from side to side when the
power is on.
Select a channel by moving the Controller upwards and downwards
when the power is on.
To view and use the Function menu, press and release the Controller
when the power is on. To close the Function menu, press and release
the Controller again.
With the Function menu visible, select the MENU (m) by moving the
Controller to the left. The OSD (On Screen Display) Menu appears.
Select an option by moving the Controller to the right. Move the
Controller to the right or left, or backwards and forwards to make
additional selections. To change a parameter, select the it, and then
press the Controller.
With the Function menu visible, select SMART HUB (™) by moving the
Controller upwards. The SMART HUB main screen appears. Select an
application by moving the Controller, and then pressing the Controller.
With the Function menu visible, open the Source (s) by moving the
Controller to the right. The Source screen appears. To select a Source,
move the Controller back and forth. When the source you want is
highlighted, press the Controller.
With the Function menu visible, select Power off (P) by moving the
Controller downwards, and then press the Controller.
English - 7
Angle adjustment wheel
Camera rear
2012-04-03
5:29:02
Advertisement
Table of Contents
