Yamaha MU5 Owner's Manual page 41

1
Operation Make sure that the MU5 is properly connected to the
device and that the HOST SELECT switch is properly set.
When using the MIDI terminals, connect the MIDI OUT of
the MU5 to the MIDI IN of the data recorder. (See the
Saving & Restoring Data via MIDI illustration above.)
Also, set the HOST SELECT switch to MIDI.
When using the TO HOST terminal, make sure that the
HOST SELECT switch is set corresponding to the device to
be used. (Refer to pages 17 – 21 for more on host computer
connections.)
2
Simultaneously hold down the s buttons and press
E.
A "Sending" message appears in the display during the
operation. Once started, the operation cannot be stopped.
When the operation is completed, the MU5 returns to the
normal Play mode.
Setting the Device Number
The settings allow you to select the device number speci-
fied for the data dump. If you are using more than one
MU5, set a different device number (1 – 16) for each unit
before sending the data. If you have only one MU5, set this
to ALL.
When using the number keys to enter a value for device
number, the value "0" corresponds to "ALL."
To reload the data from the data recorder back to the MU5:
Make sure that the devices are properly connected (see the
Saving & Restoring Data via MIDI illustrations above), and
execute the appropriate data transfer operation from the data
recorder. (Refer to the owner's manual of that device for instruc-
tions.) The MU5 automatically receives incoming bulk data.
Utility Mode
37