Downloading Fonts - Xerox 4215/MRP Reference

Image area
Fonts

Downloading fonts

XEROX MRP FAMILY PCL 5 AND POSTSCRIPT PRINTER LANGUAGE REFERENCE
For compatibility with Hewlett-Packard printers, a border area on
the outside edges of the paper is unavailable for printing when in
HP LaserJet Emulation mode. This space is approximately 0.17
inches (4.2 mm) on each side, as shown in figure 2-1. The
shaded area shows the image area.
Figure 2-1. Image area
For envelopes with HP PCL, there is a border area of
approximately 0.27 inches (7 mm) on the edge toward the front
of the printer, as well as 0.17 inches (4.2 mm) along the other
three edges, as shown in figure 2-2.
Figure 2-2. Envelope and post card edge deletion area
Feed edge
Deletion
areas
Post card
The printer implements the internal font set of the HP LaserJet
IIISi. For information on fonts, refer to the Xerox MRP Family
4220/MRP, 4230/MRP Operator Guide.
In addition to the supported fonts listed in the operator guide,
the printer can download other bitmap and scalable fonts.
Scalable Intellifont soft fonts and TrueType fonts are supported.
Downloadable fonts that are made permanent (E*c5F) or
temporary (E*c1F) are not listed on the Font Report, and cannot
be stored on the optional hard disk. Permanent fonts remain in
memory until you power off the printer or delete them.
Note: If you are running a 4220 product using a software version
N
lower than V1.54, PCL fonts cannot be stored on flash ROM.
HP LASERJET EMULATION MODE
Feed edge
Deletion
areas
Envelope
2-7