Using The Dishwasher - GE Nautilus GSD3800 Series Owner's Manual

Hide thumbs Also See for Nautilus GSD3800 Series:
Table of Contents

Advertisement

Using the dishwasher.

12
Check the Water Temperature
The entering water must be at least 120°F. and not more than
150°F., for effective cleaning and to prevent dish damage. Check
the water temperature with a candy or meat thermometer. Turn on
the hot water faucet nearest the dishwasher, place the thermometer
in a glass and let the water run continuously into the glass until the
temperature stops rising.
®
Use Jet-Dry
®
rinse agent removes spots and prevents new film build-up
Jet-Dry
on your dishes, glasses, flatware, cookware and plastic.
Fill the rinse agent dispenser
until it reaches the bottom of lip
inside the opening. Replace cap.
To check if rinse agent is needed,
remove the cap and look into the
dispenser. On some models, the
dispenser can be checked by
pressing the clear center of the
fill cap 2 or 3 times. If rinse agent
fills the center of the fill cap, you
have enough.
A full dispenser should last about one month.
If rinse agent spills, wipe up the excess.
Dish Preparation Prior to Loading
No pre-rinsing of normal food soil is required.
Scrape off hard soils including bones, toothpicks, skins, and
seeds.
Remove large quantities of any remaining food.
Remove leafy vegetables, meat trimmings, and excessive amounts
of grease or oil.
Remove acidic food soils that can discolor stainless steel.
Rinse Agent

Advertisement

Table of Contents
loading

Table of Contents