Error Message Table - TEC SL-9000 Owner's Manual

16. ERROR MESSAGE TABLE

16. ERROR MESSAGE TABLE
If you annot solve the problem with the following solution instruction, do not attempt further
trouble shooting, by yourself.
Authorized Service representative for assistance.
Do not attempt to repair or adjust alone, because electrical equipment is dangerous.
Take the following action if an error message has appeared on the commodity name display along with
the buzzer sounding.
●
Programming Mode
Message
DATA ENTRY ERROR
MEMORY FULL
DUPLICATE PLU
PLU NOT FOUND
CHARACTER OVERRUN
PRT FAILURE DETECTED Printer trouble.
LABEL OVERRUN
RESTORE THE PLUS
WARNING!
Turn the power off, unplug the printer, then contact your
Cause
Error in key input.
No memory space to set PLU.
The PLU # being changed is
already registered.
The PLU # being called out is
not registered.
Attempt is made to set more
than max. allowed number of
characters.
Label overruns.
The capacity of RAM was
changed with the ingredient
data stored.
16- 1
16. ERROR MESSAGE TABLE
Solution
Press the key, and re-input the
CLEAR
right data.
Press the CLEAR key, and delete
unnecessary PLUs.
Press the key, and check the
CLEAR
PLU.
Press the key, and set the data to
CLEAR
free PLU#.
Press the key, and re-input the
CLEAR
right data.
1. Check that the label and print head are
set correctly.
2. If the label home position is misaligned,
press the key.
FEED
FEED
Press the key.
Press the key and save the
CLEAR
ingredient data. Then delete the data from
the memory of the unit. After that change
the capacity of RAM and load the data to
the unit.