TEC SL-9000 Owner's Manual page 50

11. PROGRAMMING PROCEDURES
■
Data Transmission
The following data is down-line-loaded.
Page 1: (0). All (PLU+ING+NUTRI)
(1). PLU
(2). ING.
(3). NUTRITION
(4). U. PRICE
(5). DATE/TIME
(6). MESSAGE LINK (Message)
(7). LOCK SCALE (Check the LON cable)
(8). OPEN SCALE (Release the lock after checking the LON cable.)
(9). CHANGE PAGE
n
Enter a DLL data.
NOTE: DLL is performed automatically in the following two ways. It is selectable by the
Initial Settings #0-6 and #0-7.
(1) LOCK SCALE method
Step 1: "LOCK SCALE" is sent. (*1)
Step 2: Selected data is sent.
Step 3: "OPEN SCALE" is sent.
(2) Background DLL
Step 1: Selected data is sent.
ENTER
*1: If an error occurs during step 1, the error terminal ID# is indicated.
Select "cancel", "retry" or "continue" to release the terminal from an
error.
cancel: Quits the operation after sending "OPEN SCALE"
retry: Tries to send "LOCK SCALE" again.
continue: Ignores the error terminal and starts DLL.
*2: If an error occurs during step 2, the error terminal ID# is indicated.
Press the
CLEAR
*3: If an error occurs, the error terminal ID# is indicated. Press the
key to return to the DLL data selection menu.
Page 2: (0). SPEED KEY
(1). LOGO
(2). VENDOR
(3). FREE FORMAT
(4). ADDRESS (SL-9000N only)
(5). INITIAL (#0 - #19, SL-9000N only)
(9). CHANGE PAGE
Release the scale from the error.
0: CANCEL
1: RETRY
2: CONTINUE
(*2)
key to return to the DLL data selection menu.
(*3)
11-25
11.15 LON SYSTEM
p
CLEAR