Table of Contents
Advertisement
7.
INSTALLATION PROCEDURE
7. INSTALLATION PROCEDURE
CAUTION: Never place the scale upside down. Doing so will cause an error in weigh operation.
1.
Insert the attached remote bush into the remote pipe and push it up until it will go no further.
2.
Assemble the remote unit and secure it using the four cap screws (C-5x25).
3.
Insert two connectors into the scale unit.
4.
Secure the remote blind plate using the two screws (B-4x8).
5.
Attach the meat platter.
Meat Platter
Stopper Screw
Scale Unit
NOTE: Care must be taken when handling the remote unit because of the display tube and PC board
installed in it.
Remote Unit
Stopper Screw
Cap Screw
(C-5x25)
Remote Pipe
Remote Bush
Screw (B-4x8)
7- 1
7. INSTALLATION PROCEDURE
Remote Blind Plate
Screw (B-4x8)
Connector
Hide quick links:
Advertisement
Table of Contents
