Table of Contents
Advertisement
Installing / Removing the Base Stand
• The LCD display is very fragile, and must be protected at all times when installing and removing the base stand. Be sure
that no hard or sharp object, or anything that could scratch or damage the LCD display, comes into contact with it. DO
NOT exert pressure on the front of the TV at any time because the screen could crack.
• It is recommended that two people take part in the base installation.
1. Disconnect all cables connected to the TV.
2. Lay the TV down on a flat surface with the back side facing up, and ideally at the edge of a table so that the base of the TV
slightly overhangs on it. Please make sure a soft cushioned material (such as a pillow or thick piece of foam) is placed beneath
the screen.
Installing the Base Stand
1. Fit the stand support onto the stand base. Ensure the stand support marking position is in right position (L = left, R = right).
Align with the screw holes then screw the support by using 4 screws A supplied.
Screw A x 2
(included)
2. Slide the stand assembly under the bottom of the TV. The stand assembly will fit snugly over the screw holes. Then screw the
stand to the TV by using 4 screws B supplied.
TV Stand Base Front
• Please read this instruction manual carefully while setting up your TV.
• If you require additional assistance please call our Support Centre:
Norway: 815 56 602
TV Stand Support
(Left) (included)
TV Stand Base Front
(included)
Sweden: 0770 474 700
TV Stand Support
(Right) (included)
Screw B x 4
(included)
Denmark: 70 27 87 37
Finland: 020 - 500 6550
Preparation
2
Screw A x 2
(included)
GB
7
Advertisement
Table of Contents
