Table of Contents
Advertisement
3.2
R esetting a button to its original function
If an improved button (see chapter 2.2.2) still does not
function as expected, you can always reset the button to its
original function.
1
I n the current device
5 sec.
mode, keep digit buttons
and pressed
simultaneously for
5 seconds, until the red
Setup LED lights up.
• T he remote control is now in setup mode.
2
P ress digit buttons , ,
and , in that order.
• A fter each button press
the device selection
button blinks once.
3
P ress the button you wish
to reset twice. E.g. the 22
button.
• A fter each button press
the device selection
2 x
button blinks once.
• T he device selection button will blink one more time
to confirm that the button was succesfully reset to its
original function.
EN
4 Service and support
4.1
Frequently asked questions
In this chapter you will find answers to the most frequently
asked questions about your universal remote control.
4.1.1 Setup
I cannot enter setup mode.
Battery level too low or battery lifetime came to an end.
• R eplace the batteries. For this see chapter 2.1.
After replacing the batteries, test if the remote control
still operates your devices. If it does not, you have to set
up the remote control again. For this refer to chapter 2.2.
The brand code for my device is missing in the ‘Shortlist of
brands’ in the Quick Start Guide.
The ‘Shortlist of brands’ only mentions the most common TV,
STB, DVD player / recorder and VCR brands.
• Y ou will find a complete brand list on page 15-28 of this
user manual.
•
U se ‘9999’ as 4-digit code in case you cannot find your brand
in the complete brand list. Note that using ‘9999’ may result
in a long setup (up to 15 minutes).
My TV switches OFF in step 4 but does not switch ON
again in step 5.
TVs of some brands (e.g. Panasonic) only switch ON after
a long press on one of the digit buttons. After a long button
press in setup mode the remote control will start trying to
improve the button (see chapter 2.2.2) instead of switching
ON the TV.
• I n this case, switch ON the TV manually or use the
original remote control for this. Continue with step 6.
After successfully completing setup, the remote control
will switch ON the TV with a long button press on one
of the digit buttons, just as your original remote control.
After setup, not all buttons work as expected.
• T ry improving the button(s). See chapter 2.2.2.
EN
Page 10,
11
Advertisement
Table of Contents
