Table of Contents
Advertisement
2. Make sure that the throttle control is locked at the
idle setting when the throttle trigger lockout is
released.
3. Press the throttle trigger lockout and make sure that
it returns to its intial position when you release it.
4. Do a check of the throttle control and throttle trigger
lockout move freely and that the return springs work
properly.
5. Start the product (see instructions under
product on page 12 ) and apply full throttle.
6. Release the throttle and make sure that the cutting
attachment stops and remains at a standstill. If the
cutting attachment rotates with the throttle in the idle
position the carburettor idle setting must be checked.
See instructions under the chapter
page 13 .
1003 - 001 - 07.01.2019
To do a check of the stop switch
1. Start the engine.
2. Move the stop switch to the stop position and make
To do a check of the cutting attachment guard
The cutting attachment guard prevents injuries from
objects that eject in the direction of the operator. It also
prevents injuries that occur if you touch the cutting
attachment.
To start the
Maintenance on
1. Do a visual check for damages, for example cracks.
2. Replace the cutting attachment guard if it is
To do a check of the vibration damping system
Note: An incorrectly wound cord, or an incorrect cutting
attachment, increases the level of vibration. Refer to
Technical data on page 18 .
The vibration damping system decreases vibration in the
handles. This makes the operation easier. It also
sure that the engine stops.
WARNING: Do not use a cutting attachment
without an approved and correctly attached
cutting attachment guard. See
on page 19 .
WARNING: Always use the recommended
cutting attachment guard for the cutting
attachment that you use. If an incorrect or
faulty cutting attachment guard is fitted this
can cause serious personal injury. See
intructions under heading
page 18 .
damaged.
Accessories
Technical data on
7
Advertisement
Table of Contents
