Philips HF3485/01 Manual page 15

Philips wake-up light hf3485/01 usb playback and dusk simulation
Hide thumbs Also See for HF3485/01:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
Problem
The appliance does not
respond when I try to
set different functions.
The lamp does not go
on when the alarm
goes off.
The lamp does not go
on right away when I
switch it on.
I do not hear the alarm
sound when the alarm
goes off.
The radio does not
work.
The radio produces a
crackling sound.
The alarm went off
yesterday, but it did not
go off today.
Solution
Remove the plug from the wall socket and wait 20 minutes before you
reinsert it. When you reinsert the plug, the appliance goes back to the
factory settings and you have to set all functions again.
Perhaps you set a light intensity level that is too low. Increase the light
intensity level.
Perhaps you switched off the alarm function by setting the control lever
to the bottom position. To switch on the alarm function, set the control
lever to the middle position (alarm 1) or top position (alarm 2),
depending on the time at which you want to wake up.
Perhaps the appliance is defective. Contact the Philips Consumer Care
Centre in your country.
It takes approx. 1 second for the lamp to go on. This is normal, the lamp
needs to heat up.
Perhaps you set a sound level that is too low. To set a higher sound level,
see chapter 'Using the appliance', section 'Setting the volume'.
Perhaps you switched off the alarm function by setting the control lever
to the bottom position.
If you selected the radio as the alarm sound, the radio may be defective.
Switch on the radio after you switch off the alarm to check if the radio
works. If it does not work, contact the Philips Consumer Care Centre in
your country.
If you selected a downloaded wake-up sound or music on a USB stick
as the alarm sound, it is possible that the sounds or songs do not have
the correct format. This appliance only supports .mp3 and .wma files. If
the sound or music on the USB stick cannot be played, the appliance
automatically sets the bird sound as alarm sound to ensure
that you wake up at the set alarm time anyway.
The radio may be defective. Contact the Philips Consumer Care Centre
in your country.
Perhaps you set the volume too low. Increase the volume level.
Perhaps the broadcast signal is weak. Adjust the frequency (see chapter
'Using the appliance' section 'Using the radio/playing music from a USB
stick') and/or change the position of the antenna by moving it around.
Make sure you have unwound the antenna completely.
Perhaps you switched off the alarm function by setting the control
lever to the bottom position.
Perhaps you set a volume level and/or light intensity level that is too
low. Set a higher volume level and/or light intensity level.
EnglisH
15

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hf3485/60Hf3485

Table of Contents