Range Hood Use; Range Hood Controls; Range Hood Care; Cleaning - Whirlpool UXT4030ADB Installation Instructions And Use & Care Manual

RANGE HOOD USE

The range hood is designed to remove smoke, cooking
vapors, and odors from the cooktop area. For best results,
start the hood before cooking and allow it to operate several
minutes after the cooking is complete to clear all smoke and
odors from the kitchen.
The hood controls are located on the front panel of
the range hood.
A
A. Light housing and cover
B. Grease filter retainer
C. Grease filter

Range Hood Controls

On Off
A
A. On/Off light switch
B. Fan speed switch
Operating the light
Press the light switch to the left to turn the light On.
Press the light switch to the right to turn the light Off.
Operating the fan
The fan has 2 speeds.
Press the fan switch to the left for Low speed.
Press the fan switch to the right for High speed.
Return the fan switch to the center to turn the fan Off.

RANGE HOOD CARE

Cleaning

IMPORTANT: Clean the hood and grease filters frequently
according to the following instructions. Replace the grease
filter before operating hood.
Exterior Surfaces
IMPORTANT: Do not use soap-filled scouring pads,
abrasive cleaners, cooktop polishing creme, steel wool,
gritty washcloths, or paper towels.
To avoid damage to the stainless steel, do not use cleaners
that contain chlorine.
C
B
Off
Low High
B
Cleaning Method:
Liquid detergent or all-purpose cleaner:
■
Rinse with clean water and dry with a soft, lint-free cloth.
Glass cleaner to remove fingerprints.
■
For stainless steel models, rub in the direction of the
■
grain to avoid scratching or damaging the surface.
For stainless steel models, use Stainless Steel Cleaner
■
and Polish, Part Number 31462A (not included):
See the "Assistance or Service" section to order.
Charcoal Grease Filter
To Remove the Filter:
1. Remove the screw from the grease filter retainer.
2. Turn the grease filter retainer to release the filter.
A
A. Filter retainer
3. For non-vented (recirculating) installations: The charcoal
filter is not washable. It should last up to 6 months with
normal use. For information on ordering, see the "Assistance
or Service" section. Dispose of the old charcoal filter.
To Replace the Filter:
1. To reinstall the filter, place the back edge of the filter into the
channel at the rear of the hood. Push the filter into place and
turn the filter retainer to secure the filter to the range hood.
2. Replace the screw in the grease filter retainer.
Replacing the Light Bulb
Turn off the range hood and allow the light bulb to cool.
1. Disconnect power.
2. Squeeze the plastic lens cover and remove it from the hood.
3. Screw a 120V, 75W maximum, light bulb with
E26 base into the socket.
4. Replace the lens cover by squeezing the cover
and inserting the tabs into the slots.
5. Reconnect power.
If the new light does not operate, make sure the light bulb
is inserted correctly before calling service.
9