Philips SCF870/20 Manual page 16

EngliSh
16
Problem
The appliance
continues to give
off an unpleasant
smell after I used it
a few times.
The appliance
makes a lot of
noise, produces an
unpleasant smell,
feels hot to the
touch, emits
smoke, etc.
The lid of the jar
leaks.
There are white
spots on the filling
opening and/or on
the jar, sieve and
lid.
The appliance
produces a lot of
noise while it is
blending.
The water in the
water tank has an
unusual colour
when you pour it
out of the water
tank or when it
enters the jar
during steaming,
or the water in
the water tank has
an unpleasant
smell.
4203.000.6226.2.indd 16
Possible cause Solution
You put too much Process smaller quantities and do not let the
food in the jar or appliance blend for more than 30 seconds at a
you let the appliance time.
blend too long.
There is too much Switch off the appliance and process a smaller
food in the jar. quantity.
You let the appliance Do not let the appliance blend for more than 30
operate too long seconds at a time.
without interruption.
You have not Assemble the lid on the jar properly. See chapter
assembled the lid on 'Using the appliance'.
the jar properly.
There is too much Switch off the appliance and process a smaller
food in the jar. quantity.
Scale has built up on This is normal. Remove the scale periodically. See
these parts. chapter 'Cleaning and maintenance', section
'Descaling'.
The sieve is not Make sure that the sieve is attached to the lid of
attached to the lid of the jar.
the jar.
Food particles have Clean the water tank according to the instructions
entered the water in chapter 'Cleaning and maintenance, section
tank during use. 'Descaling the water tank'. Use the appliance strictly
according to the instructions. Make sure you do not
overfill the water tank with water (max 200ml) and
that you do not overfill the jar with food (do not fill
the jar beyond the top edge of the green blade
unit). Do not steam the same ingredients for more
than 20 minutes and do not put water for steaming
directly in the jar. Also make sure that the valve is
fixed in the lid.
05-11-10 13:21