Philips SCD525/00 User Manual page 17

Why does the LINK light on the parent unit
light up red continuously and why is the message
'Searching' shown on the display?
• The baby unit and the parent unit are out
of range of each other. Move the parent unit
closer to the baby unit.
• The baby unit may be switched off. Switch on
the baby unit.
• The ECO mode is switched on, but the
operating range is too large. Move the parent
unit closer to the baby unit or switch off the
ECO mode.
Why does the battery light on the baby unit
flash red?
• The non-rechargeable batteries of the baby unit
are running low. Replace the non-rechargeable
batteries or connect the baby unit to the mains
(see chapter 'Preparing for use').
Why does the parent unit beep?
• If the parent unit beeps while the LINK light
lights up red continuously and the message
'Searching' is shown on the display, the
connection with the baby unit is lost. Move the
parent unit closer to the baby unit.
• If the parent unit beeps and the battery symbol
on the display is empty, the rechargeable
batteries of the parent unit are running low.
Recharge the batteries.
• If you have switched off the volume while
the sound alert is on, the parent unit beeps
whenever the fourth sound level light lights up
because the baby unit has picked up a sound.
• If you have set the room temperature range on
the parent unit and the temperature alert is on,
the parent unit beeps when the temperature
drops below the set level or below 14°C or
when the temperature rises above the set level
or above 35°C.
• The baby unit may be switched off. Switch on
the baby unit.
Why does the appliance produce a high-
pitched noise?
• The units may be too close to each other.
Make sure the parent unit and the baby unit
are at least 1 metre/3.5 feet away from
each other.
• The volume of the parent unit may be set too
high. Decrease the volume of the parent unit.
Why don't I hear a sound/Why can't I hear
my baby cry?
• The volume of the parent unit may be set
too low or may be switched off. Increase the
volume of the parent unit.
• The microphone sensitivity level of the baby
unit may be set too low. Set the microphone
sensitivity level to a higher level in the menu of
the parent unit.
• The baby unit and the parent unit may be out
of range of each other. Reduce the distance
between the units.
Why does the parent unit react too quickly to
other sounds?
• The baby unit also picks up other sounds than
those of your baby. Move the baby unit closer
to the baby (but observe the minimum distance
of 1 metre/3.5 feet).
• The microphone sensitivity level of the baby
unit may be set too high. Decrease the
microphone sensitivity level in the menu of the
parent unit.
Why does the parent unit react slowly to the
baby's crying?
• The microphone sensitivity level of the
baby unit may be set too low. Increase the
microphone sensitivity level of in the menu of
the parent unit.
17