Pull the colour code ring from the bottom of the brush head.
Install a new ring by slipping one edge of the new ring over the
bottom of the brush head.
Attaching the brush head
Align the brush head so the bristles face the front of the handle.
Firmly press the brush head down on the metal shaft until it stops.
Note: There is a small gap between the colour code ring and the handle.
charging your sonicare
Put the mains plug of the charger or sanitiser in the wall socket.
Place the handle on the charger or sanitiser.
The flashing light of the battery gauge indicates that the toothbrush
1 solid green LED indicates that the toothbrush is 34-66% charged.
2 solid green LEDs indicate that the toothbrush is 67-94% charged.
3 solid green LEDs indicate that the toothbrush is fully charged.
Note: If the battery charge of your Sonicare is low, you hear 3 beeps and 1
LED of the recharge gauge flashes yellow for 30 seconds after completing the
Note: To keep the battery fully charged at all times, you may keep your
Sonicare on the charger when not in use. Once the Sonicare is fully charged,
the charger draws minimal energy from the wall socket.
Note: It takes at least 24 hours to fully charge the battery.