01.SM-308-GB
1/3/02 6:27 PM
Your Combo Drive
1
2
1. Earphone connection terminal
2. Volume control
3. Disc compartment
4. Emergency eject hole (if the compartment does not open when
you press the Eject button, insert a pin or unfolded paper clip in the
hole and push firmly)
5. Indicator light (when it is green, a disc is being read or recorded)
6. Eject button
1
2
3
1. Digital output terminal
2. Sound output terminal
3. Master/slave select terminal
4. Interface terminal
5. Power terminal
Page 4
3
4 5 6
4
5
4
Upgrading the Firmware Flash Memory
The product firmware can be upgraded by downloading the updated file from the
following Web site:
http://www.samsungodd.com
www.samsungelectronics.com
System Requirements
Before you install the COMBO drive, we strongly recommend that you
check that your setup meets the system requirements listed below.
Item
Description
Computer
Intel Pentium II 300MHz/Celeron 333A(or higher),
32 MB of RAM (or higher) with an IDE interface
Free expansion unit
5.25 inch
Disk space
700 MB minimum
Windows version
Windows 95/98/2000/ME/NT4.0 OSR2 (or higher)
(For Windows NT, we recommend Service Pack2,
and Version is over 4.00.1381)
MS-DOS
5.0 or higher (For MS-DOS, The CD-R/CD-RW driver
can only read a disc without premaster Software.)
DVD Video playback
PC with Windows 95/98/2000/ME/XP/NT4.0 OSR2
DVD-Video playback software and appropriate hardware
(the Power DVD MPEG software is included in the
COMBO drive package)
Installing the COMBO Drive
To install your COMBO drive in the PC, proceed as follows.
1
Make sure that the PC is powered off and disconnected from any power source.
2
If necessary, attach a horizontal bracket to both sides of
the drive.
Use of the brackets depends on your computer
model; you can purchase these accessories
separately from your computer dealer.
3
Remove the cover from a free expansion slot and install
the COMBO drive, as shown in the illustration.
If you have no free expansion slot, install the drive in
place of the diskette drive.
5
COMBO drive
Need help?
Do you have a question about the SM-316 and is the answer not in the manual?