Related Manuals for Philips CSP1000/93
Summary of Contents for Philips CSP1000/93
- Page 1 Register your product and get support at www.philips.com/welcome CSP1000 CSP1200 EN User manual...
-
Page 2: Environmental Information
Your system consists of materials which can be recycled and reused if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging materials, exhausted batteries and old equipment. Any changes or modifications made to this device that are not expressly approved by Philips Consumer Lifestyle may void the user’s authority to operate the equipment. 2009 © Koninklijke Philips Electronics N.V. All rights reserved. Specifications are subject to change without notice. Trademarks are the property of Koninklijke Philips Electronics N.V. or their respective owners. Philips reserves the right to change products at... -
Page 3: Installation
Your car power subwoofer Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. Introduction With the subwoofer, you can enjoy high quality sound performance with powerful bass and beats. What’s in the box Check and identify the contents of your package: Subwoofer Screw_4x50mm (x10) Frame 2. Installation A depth of at least 124mm is required to mount the subwoofer. Measure the depth of the area where you are to mount the subwoofer, and ensure that the subwoofer does not obstruct any other components of the car. - Page 4 Turn off the car ignition key. If the power is on, the click noise generated by the connection • may damage the speakers. Paste the supplied template onto the location for mounting the subwoofer. Mark the cut-off hole and the 10 bolt holes. Cut out the marked areaa and drill the bolt holes.
- Page 5 Connect the subwoofer to the amplifier. 10 ~ 15mm Speaker wire (not supplied) Mount the subwoofer into the rear tray with the supplied screws. Amplifier...
- Page 6 Option 2: Install in a sealed enclosure If the subwoofer cannot be mounted on the car, place it in a sealed enclosure. Make a sealed enclosure in dimension as below: The box: CSP1000 Height 338mm Length 522mm Width 232mm The mounting hole: Mounting hole diameter (Outside) Mounting hole diameter (Inside) Screw hole diameter Connect the subwoofer to the amplifier (see step 5 of “Option 1: Mount on rear tray” section).
-
Page 7: Product Information
Install the subwoofer into the sealed enclosure with the supplied screws. 3. Product information Note • Product information is subject to change without prior notice. Model Speaker type RMS power (Watts) Peak music power (Watts) Sensitivity (dB/W/m) Frequency response (Hz) Impedance (ohms) Magnet mass (Oz) Mounting depth (mm) CSP1000 CSP1200 25cm subwoofer... -
Page 8: Troubleshooting
4. Troubleshooting To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this apparatus, go to the Philips web site (www.philips.com/welcome). When you contact Philips, ensure that the apparatus is nearby and the model number and serial number are available. Name of the Parts...