Table of Contents
Advertisement
8
Press and insert the edges of the grille net.
Tip
•
The speaker grille can be mounted without the grille net, if you like.
Option 2: Mount on rear tray
You can also mount the woofers into the surface of the rear tray.
Follow the steps in section "Option 1: Mount in door" to mount the
speakers into the rear tray.
Mount the Tweeter
Follow steps mentioned in "Mount the woofer" section to mount the
tweeters.
Mount the network
1
Find a proper location to mount the networks.
2
Mount the networks onto the car with the supplied screws.
Connect the woofer/tweeter to the network
Note
•
Match the "left", "right", "+" and "-" terminals correctly. Revised polarity may
degrade sound quality.
•
Two 4-ohm speakers, wired in stereo, present a 8 ohm load to each channel
of the amplifier. Most two channel amplifiers work well in this configuration.
However, if two 4-ohm speakers, wired in parallel to a bridged two -channel
amplifier, present a 2-ohm mono load to the amplifier. Most 2-channel amplifiers
do not support 2-ohm mono operation! Amplifier damage may result!
C
D
E
f
F
Advertisement
Table of Contents
