Download Print this page

Overview Of Parts; Connect Wires - Philips CEM5000/51 Quick Start Manual

Philips car stereo system quick start guide
Hide thumbs Also See for CEM5000/51:

Advertisement

English

Overview of parts 1

These are the supplied parts needed to connect
and install this unit.
a In-car audio system and sleeve
b Front panel
c Standard connector
d Trim plate
e Rubber cushion
f Disassembly tools
g Screws (4 pieces)

Connect wires

Caution
Ensure that all loose leads are insulated with
electrical tape.
ISO connectors 2 3
1
Pull out the ISO connectors from the car
dashboard and connect them to the bigger
end of the supplied standard connector.
2
Connect the other end of supplied standard
connector to the unit.
3
Do the other connections, if applicable.
Without ISO connectors 3 4 5
1
Cut off the bigger end of the supplied stan-
dard connector.
2
Check the car's wiring carefully, then connect
them to the standard connector.
3
Connect the supplied standard connector to
the unit.
4
Do the other connections, if applicable.
Connector
Connect to
1
Black wire
A metal surface of the car
First connect the black
ground (earth) lead, then
connect the yellow and red
power supply leads.
2
Yellow wire The +12V car battery which
is live at all times.
3
Blue wire
Motor/electric antenna relay
control lead/Amplifier relay
control lead
The +12V power terminal
4
Red wire
which is live in the accessory
(ACC) position of the igni-
tion switch
If there is no accessory posi-
tion, connect to the +12V car
battery terminal that is always
live. Be sure to connect the
black ground (earth) lead to
a metal surface of the car first.
5
Green and
Left speaker (Rear)
green/black
wires
6
White and
Left speaker (Front)
white/black
wires
7
Gray and
Right speaker (Front)
gray/black
wires
Right speaker (Rear)
8
Purple and
purple/black
wires
Mount in the dashboard 6
1
If the car does not have an on-board drive or
navigation computer, disconnect the negative
terminal of the car battery.
If you disconnect the car battery in a car
that has an on-board drive or navigation
computer, the computer may lose its
memory.
If the car battery is not disconnected,
to avoid short-circuit, ensure that bare
wires do not touch each other.

Advertisement

loading

This manual is also suitable for:

Cem5000