Assembly - Dexter Laundry 450ETC1-18033.1 Instruction Manual

6. ASSEMBLY

FR
ES
PT
MOUNTING THE CUTTING BLADE
• Attach the staight wrench to the hex nut.
IT
• Use angle wrench to lock the motor shaft.
• Loosen the hex nut, remove it and outer flange.
• Place one new cutting disc on inner flange with arrows on cutting disc going in the counterclockwise
EL
direction.
• Attach the outer flange.
PL • Screw hex nut onto motor shaft clockwise.
• Attach the straight wrench to the hex nut.
• Use angle wrench to lock the motor shaft.
UA
• Tighten hex nut clockwise using straight wrench.
• Screw the lower blade cover into place and attach the water tank.
RO
MOUNTING THE UPPER BLADE GUARD BRACKET
• Clean all rust protected surfaces with a mild solvent.
• Loosen two screws with screwdriver (not included) then attach the upper blade guard bracket using
EN
two screws.
MOUNTING THE UPPER BLADE GUARD
• Attach the upper blade guard to the upper blade guard bracket with 1 plastic knob and nut.
ADJUSTING THE UPPER BLADE GUARD
• The blade guard must always be used.
• The saw guard must be lowered to the work piece to minimise the amount of exposed blade.
• Ensure that upper blade can move freely and that it cannot touch the cutting disc when in use.
MOUNTING THE PARALLEL GUIDE
Setup adjustments of the cutting blade shall never be performed when the machine is running. Set the
parallel guide at the both ends of the table, place it in the cutting position and tighten the parallel
guide locking lever in the front.
FILL THE WATER TANK
Fill the water tank up to the max. level mark.
WARNING ! Pull out the power plug before assembling, adjusting
and changing the cutting disc.
WARNING ! The upper blade guard bracket must always be
aligned to the cutting blade so that the upper blade guard
bracket does not Interfere with material being cut.
WARNING ! Do not over-tighten the plastic knob. The upper
blade guard must be free.
115