Advertisement
6 INSTALLATION PLACE
1)
Recommended installation height is at least
2m and at a distance not more than 6m from
the most distant spot of protected
2)
The detector cannot be used in premises
with high level of acoustic
interference.
3) Alarm loop wires should be located far from
power cables.
To eliminate false alarm hazards
1)
It is recommended close doors and vents,
switch off fans, loud-speakers and other possi-
ble sources of acoustic interference in the room
during protection
period.
2)
The detector's location should provide di-
rect visibility of all secured glass parts; masking
the detector with decorative curtains is not al-
lowed, as sensitivity may be
lost.
Not recommended installation places
7 INSTALLATION PROCEDURE
1) Remove the cover
2) Remove PCB
3) Push out wire
insertion holes caps.
glass.
Detector base should be positioned strictly
as per figure!
4) Install PCB and
perform wiring
(see p.8)
8 WIRING
Perform
wiring
accordance with control panel operating manual.
4) Mount on a wall.
5) Perform GB-channel
test (see p.9)
to
detector`s
terminals
in
RES – terminating resistor connection terminal;
TMP – detector tampering control terminals;
RELAY – terminals for detector connection to
alarm loop (zone);
+12V, GND – power supply terminals.
9 TEST
1)
Install jumpers on Green, Red, Sens0,
Sens1 plugs. Remove jumper from Mem plug.
2)
Close the detector.
3) Power ON the detector.
4) Apply non-destructive strike to the most
distant part of the protected glass.
5) At the detection moment the red LED
should light up for 7s and relay should open
(check with the control panel) or green LED
should double-flash one time.
10 WARRANTY
The operation warranty period is 5 years from
the date of operation start-up but no longer than
5 years 6 months from the date of manufactur-
ing
subject to the requirements of Operating
Manual.
Advertisement
