Table of Contents
Advertisement
5. Important safety information
1) Safety gear must be worn while operating the machine.
2) If more than two people are operating the machine, observe the others'
movement carefully.
3) Make sure there is NO on or no obstacle within the operating area and
its range.
4) Do NOT overload or apply excessive force to the equipment.
5) Perform "pre-operation"procedures. In particular, check for loosen nuts
and bolts, connecting pins, and Lubricant.
6) If any trouble occurs while operating the equipment, turn off the engine
of tractor and apply the break, then refer to "Trouble Shooting."
7) Comply with all local traffic regulations while driving.
8) After assembling universal joint (before trial run), if joint is too long, or
the angle between the tractor's PTO and the spreader exceeds.
recommended angle, then it may cause the breakage of the gear box.
※ Recommended angle is 15 degree
※ A PTO driveline that is too long and "bottoms out" could possibly cause
severe damage to the gearbox. It is
proper PTO driveline length for your tractor.
Gearboxes damaged by incorrect PTO driveline length are
by warranty.
VERY IMPORTANT
- 7 -
to check the
NOT covered
Advertisement
Table of Contents
