Unpacking; Installation - omi ED HP40 Instruction And Maintenance Manual

2.3 UNPACKING

The packaging is made of carton or of cellophane. We recommend that you keep the original packaging for the device in case it has to
be transported to another location or sent to a service center. Dispose the various packaging materials in compliance with the relevant
rules locally in force.
•
unpack the device, removing the strapping from the carton. Always wear safety gloves when using scissors or other tools to cut the
straps or the cellophane;
•
remove the carton or the cellophane;
•
in case it's necessary another handling of the device, refer to section 2.1;
•
remove the pallet (if present);
•
remove the operating manual, accessories and key from the device.

2.4 INSTALLATION

Before attempting any installation operation, make sure that
 No parts of the air system are under pressure.
 No parts of the system are electrically powered.
 Tubing to be connected to the dryer are free of impurities.
 The pipes to be connected to the dryer does not weigh on the device.
 All interconnecting piping has been tightened.
After having verified the points listed above, you can proceed to the installation of the machine.
1. Connect the dryer to the compressed air lines. If not already existing, we suggest to install a by-pass allowing to
isolate the machine from the plant, thus to facilitate eventual maintenance operations.
2. Perform the electrical connection in accordance with any local laws and regulations after reviewing the dryer
electrical specifications and wiring diagram.
3. Check the condensate drainage assembly, and connect the drain flexible hose to the draining line, keeping in
mind that the condensate separated by the dryer may contain oil, therefore, in order to dispose of it in
compliance with the local rules in force, we suggest installing a water-oil separator having adequate
capacity.
4.
Power the dryer after having checked that the nominal voltage and line frequency are constant and matching the
nominal values of the machine. The user must provide the installation with an adequate line protection
and a ground terminal complying with the electrical rules locally in force.
In order to optimise the use of the dryer, we suggest to place it in such a way that all the control instruments
of the machine will result easily visible.
Installing a ceramic pre-filter on the air inlet of the dryer, this will be better protected from eventual
solid particles, as it prevents the accumulation of oily materials on the heath exchangers.
1
Air Compressor
2
Aftercooler
3
Condensate Separator
4
Receiver
5
Automatic Drain
6
Ceramic Prefilter 10μ
7
Dust Filter 5μ
8
Dryer
9
Solenoid drain valve
10
Coalescing Filter 1μ – 0.1 mg/m
11
Coalescing Filter 0.01μ – 0.01 mg/m
12
Activated carbon filter 0.003 mg/m
13
Water/Oil Separator
Pic. 1
Cod. 710.0150.01.00 Rev.03 – 09.2019
3
3
3
ENGLISH
15 - 73