Configuring Wpa On The Vt2500 - Motorola VT2500 User Manual

Overview Installation Troubleshooting Contact

Configuring WPA on the VT2500

After you enable and configure WPA on the VT2500, you must configure each WLAN client as described in the
subsections under "Configuring the Wireless
To enable WPA and set the key on the VT2500:
1
On the VT2500 Setup Program menu, click Wireless.
2
Click the SECURITY tab to display the
3
In the Security Mode field, select WPA and click Apply.
4
Under WPA CONFIGURATION, choose one WPA Encryption type. Because performance may be slow with
TKIP, we recommend choosing AES if your clients support AES:
TKIP Temporal Key Integrity Protocol provides data encryption including a per-packet key mixing
function, message integrity check (MIC), initialization vector (IV), and re-keying mechanism.
AES The Advanced Encryption Standard algorithm implements symmetric key cryptography as a
block cipher using 128-bit keys. We recommend this setting if all of your wireless clients
support AES. The Motorola client adapters shown in
Group Rekey Set the WPA Group Rekey Interval in seconds. Set to zero to disable periodic rekeying. The
Interval value should be from 0 - (2^32 -1).
VT2400/VT2500 Series Voice Gateway User Guide
Configuration: Basic Advanced
Clients".
Wireless > SECURITY — basic
FAQ Specifications Glossary License
TCP/IP Wireless
page:
"Optional Accessories" support AES.
96