Processor Adjustment Range - Sony HDV HVR-1500 Operating Instructions Manual

Band width (625/50)
Composite/S-video:
25 Hz to 4.8 MHz ±1.0 dB (Y)
Component :
25 Hz to 5.0 MHz ±1.0 dB (Y)
25 Hz to 2.0 MHz +1.0/ − 2.0 dB (R −
Y/B − Y)
S/N Composite/S-video I/O (Y):
52 dB or more
Component I/O (Y): 54.5 dB or more
Y/C delay 30 ns or less
K-factor 2.0% or less (K2T, KPB)

Processor adjustment range

1) ±3 dB/ −∞ to 3 dB selectable
Video level
1) ±3 dB/ −∞ to 3 dB selectable
Chroma level
1)
Setup/Black level
±30 IRE (±210 mV)
1)
Chroma phase ±30°
1)
System phase Sync: ±1μs
SC: ±180°
1) Adjust with menu settings.
Audio performance
Frequency response
Two-channel (48 kHz) mode:
20 Hz to 20 kHz ±1.0 dB
Four-channel (32 kHz) mode:
20 Hz to 14.5 kHz ±1.0 dB
Dynamic range More than 87 dB
Distortion (THD + N)
Less than 0.07% (48 kHz)
Input connectors
Digital signal inputs
SDI IN BNC type (×1), Serial digital (270 Mbps),
SMPTE 259M/ITU-R BT.656
AUDIO (AES/EBU) IN
BNC type (×2), complying with AES-
3id-1995
HDV/DV 6-pin IEEE 1394 connector (×1)
Analog video inputs
REF. VIDEO IN
BNC type (×2, loop-through with 75 Ω
automatic terminator)
Black burst or Composite sync
0.286 Vp-p (525/60) or 0.3Vp-p (625/
50), 75 Ω , negative sync or HD bipolar
tri-level sync
0.3Vp-p, 75 Ω , negative sync
VIDEO IN (optional HVBK-1505 Analog Input Board
required)
BNC type (×3 and 1 loop-through
connector with 75 Ω automatic
terminator), composite/component
(SD)/S-video switchable
Y/S − Y/CPST and 1 loop-through
Composite
connector with 75 Ω automatic
terminator: 1.0 Vp-p, 75 Ω , negative
sync
Component (SD)
Y/S − Y/CPST: 1.0 Vp-p, 75 Ω , negative
sync
R − Y/S − C and B-Y: 0.7 Vp-p (75% color
bars for 525/59.94 or 100% color bars
for 625/50), 75 Ω
Y/S − Y/CPST: 1.0 Vp-p, 75 Ω , negative
S-video
sync
R − Y/S − C: 0.286 Vp-p (525/59.94) or
0.3 Vp-p (625/50), 75 Ω (burst level)
Analog audio inputs
AUDIO IN (optional HVBK-1505 Analog Input Board
required)
XLR 3-pin, female (×2), +4/0/ − 3
− 6 dBm, high impedance, balanced
1) For 625/50 only
Timecode input
TC IN BNC type, SMPTE timecode (525/59.94)
or EBU timecode (625/50), 0.5 Vp-p
to 18 Vp-p, 3.3 k Ω , unbalanced
Output connectors
Digital signal outputs
SDI OUT BNC type (×2)
Serial digital (270 Mbps), SMPTE 259M/
ITU-R BT.656
HD-SDI OUT BNC type (×2)
Serial digital (1.485, 1.485/1.001 Gbps),
SMPTE 292M
AUDIO (AES/EBU) OUT
BNC type (×2), complying with AES-
3id-1995
HDV/DV 6-pin IEEE 1394 connector
Analog video outputs
VIDEO OUT BNC type (×3), composite+S-video/
component (SD)/component (HD)
switchable
Y/CPST: 1.0 Vp-p, 75 Ω , negative sync
Composite
Component (SD)
Y/CPST: 1.0 Vp-p, 75 Ω , negative sync
Pr/R–Y/S–C and Pb/B–Y/S–Y:
0.7 Vp-p (75% color bars for 525/
59.94 or 100% color bars for 625/50),
75 Ω
Component (HD)
Y/CPST: 1.0Vp-p, 75 Ω , negative sync
Pr/R–Y/S–C and Pb/B–Y/S–Y: 0.7Vp-p,
75 Ω
1)
/
101
Specifications