Advertisement
WARNING! For work with grinding or cutting discs, the protection guard must always be mounted. Use the correct type of disc for
‰
your application.
4.2.1.
Wheel guard for cutting (See Fig.1)
Fix the outer guard onto the inner guard until it engages. The inner guard and outer guard assembled together and make up a
wheel guard for cutting.
4.2.2.
Wheel guard for grinding (See Fig.2)
Simply remove the outer guard. The inner guard is used as wheel guard for grinding.
4.2.3.
Adjusting the wheel guard (See Fig.3)
Turn the wheel guard to the desired position until it engages. No tool is required for this.
4.3.
REPLACING THE CUTTING DISC/GRINDING DISC
fig.4
WARNING! DO NOT touch grinding and cutting discs before they have cooled down. The discs can become very hot while
‰
working.
4.3.1.
Clean the spindle and all parts to be mounted.
4.3.2.
Press and hold the spindle lock button to lock the spindle. You may need to rotate the spindle using the provided hex key if the spindle
lock button cannot be pressed down to the end.
4.3.3.
Loosen the clamping bolt with washer by turning it anti-clockwise using the provided hex key.
4.3.4.
Remove the clamping bolt with washer and the disc.
WARNING! Actuate the spindle lock button when the grinder spindle is at a standstill. Otherwise, the machine may become
‰
damaged.
WARNING! Pay attention to the dimensions of the grinding/ cutting discs. The mounting hole diameter must fit the spindle without
‰
play. DO NOT use reducers or adapters
4.3.5.
Place the disc on the tool spindle. Ensure it is correctly located.
4.3.6.
Insert the clamping bolt with washer through the centre of the disc and onto the spindle.
4.3.7.
Press and hold the spindle lock button to lock the spindle. You may need to rotate the spindle using the provided hex key if the spindle
lock button cannot be pressed down to the end.
4.3.8.
Tighten the clamping bolt with washer by turning it clockwise using the provided hex key. Make sure that the cutting disc/grinding disc
is assembled firmly.
WARNING! After mounting the grinding/ Cutting disc and before switching on, check that the disc is correctly mounted and that it
‰
can turn freely. Make sure that the disc does not graze against the wheel guard or other parts.
4.4.
APPROVED GRINDING/CUTTING DISC
The permissible speed [min-1] or the circumferential speed [m/s] of the grinding tools used must at least match the values given in the
specification table.
5. OPERATION
5.1.
BEFORE OPERATION
5.1.1.
CHARGING THE BATTERY
DO NOT use any charger other than that specifically provided for use with the equipment.
8
If the battery pack is very hot you must remove your battery pack from the charger and allow time for the battery to cool down before
9
recharging.
5.2.
REMOVING OR INSTALLING THE BATTERY PACK (SEE FIG.6&7)
WARNING! Before inserting the battery pack, make sure that the on/off switch is in OFF position.
‰
Depress the battery pack release button to release and slide the battery pack out from your tool. After recharge, slide it back into your
tool. A simple push and slight pressure will be sufficient.
fig.6
© Jack Sealey Limited
fig.7
Original Language Version
fig.5
CP108VAGBO Issue 1 29/04/2021
Advertisement
