CAME FUTURAKITVC04 Installation Manual page 11

Programming an intercom group
y
Programming of the intercom group must only take place AFTER assigning a call button to all the extensions.
a



Disabling the intercom function
M1
a

With the jumper SW3 connected, press the PROG button for at least 8 seconds and
>8''
release it (within 11 seconds) a as soon as the PROG LED flashes and the backlighting
<11''
on the buttons comes on as shown in figure .
PROG
To enable the intercom function, go to the internal extension that you want to program
and press the call button to be used to intercom call it: an acoustic signal will confirm
the programming . Continue by repeating the same operations for all the other in-
SW3
ternal extensions to be included in the intercom group. At the end, briefly press the
PROG button .
N.B. If no action is performed, the procedure will automatically end after 30
minutes.
PROG
y
SW3
the assignment of a call button, it can no longer be excluded from the group. If
you want to change the call button for an internal extension that is already pro-
3 beep
grammed as intercommunicating or add new internal extensions to the group,
simply repeat the sequence of steps described for "Programming an intercom
group".
<1''
PROG
SW3
M2
To deactivate the intercom function, you simply have to disconnect the SW3 jumper a;
by doing this, programming of the intercom system is also inhibited.
PROG
To re-activate this same function, simply re-insert the SW3 jumper .
SW3
M2
PROG
SW3
M2
Once an internal extension has been included in an intercom group through