CAME FUTURAKITVC04 Installation Manual page 10

<1''
PROG
SW3

Reprogramming procedure
PROG
a
SW3

<1''
PROG
SW3

>3''
<6''
PROG

SW3

M1
BOUT
Exiting programming. Briefly press the PROG button: the PROG LED goes off.
N.B. If no action is performed, the procedure will automatically end after 30 minutes.
Accessing programming. Press the PROG button a for at least 3 seconds and re-
>3''
lease it (within 6 seconds) as soon as the PROG LED flashes and the backlighting on the
<6''
buttons comes on as shown in figure . If the PROG LED does not come on, this shows
a fault. Check the connections and go back to programming.
PROG

SW3
Programming the call keys. Press the door lock release
On the entry panel, press the call key to associate with the internal extension : an
acoustic signal will confirm that the setting was stored. Hang up the receiver again.
Repeat the same operations for the other extensions.

Exiting programming. Briefly press the PROG button : the PROG LED goes off. N.B.
If no action is performed, the procedure will automatically end after 30 minutes.
Programming button type. At the "Programming Call Buttons" stage, press the PROG
button  for at least 3 seconds and release it (within 6 seconds) as soon as the PROG
LED comes on and the backlighting on the buttons flashes as shown in figure  ,
entring the "Programming button type" procedure.
Press the first button on the entry panel in the position marked  until the backlit LEDS
M2
stop flashing  and remain lit.
At the end, to exit programming, briefly press the PROG button  : the PROG LED goes
off. If no action is performed, the procedure will automatically end after 30 minutes.

PROG

M1
SW3
BOUT
beep
and AUX2  buttons.
M2